판매가 | |
---|---|
할인판매가 | 5,700원 (5,700원 할인) |
할인금액 |
총 할인금액 원 (모바일할인금액 원) |
적립금 |
0원(1.00%) 원% 원% 원% 원% 원% 원% 원% 원% 원% 원% 원% 원% 원% |
제휴적립금 | |
배송방법 | 택배 |
배송비 | 2,700원 ~ 3,000원 |
상품 추가설명 번역정보 |
배송 | |
---|---|
수량 |
상품 정보 | 가격 | 삭제 |
---|---|---|
총상품금액(수량)0 |
2개의 DC 모터 제어용 드라이버 보드입니다.
안내. 사용법 안내 사이트 링크: http://bildr.org/2012/04/tb6612fng-arduino/
Description: The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode.
Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
Board comes with all components installed as shown. Decoupling capacitors are included on both supply lines. All pins of the TB6612FNG are broken out to two 0.1" pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.
Note: If you are looking for the SparkFun Motor Driver with headers, it can be found here or in the Recommended Products below.
GET STARTED WITH THE MOTOR DRIVER HOOKUP GUIDE
Features:
Dimensions: 0.8x0.8"
Documents:
01. 결제(입금완료)완료 후 2-3일이내에 상품을 수령하실 수 있습니다. 02. 재고가 없거나 다시 재입고 될 경우(예약상품, 구두포함) 5-7일이 소요됩니다. 03. 배송비는 5만원 이상 구매시 무료 5만원 미만 구매시 2500원의 배송료가 있습니다.
반품은 반드시 정해진 택배사를 이용해주세요. 반드시 고객센터나 게시판을 통해 반품의사를 알려주신 후 제품을 보내주셔야 합니다. 연락없이 보내실경우 반품 및 교환이 불가능합니다. 반품 및 교환에 대한 자세한 사항은 아래의 내용을 참고해주세요.
제품을 받으신 후 일주일 이내에 교환, 반품신청을 하지 않았을 경우 고객님의 부주의로 인한 상품이 변형, 훼손 또는 파손 된 경우 제품이 오염되었을 경우 (립스틱, 화장품, 음식물 기타 오염물질로 인해) 제품을 착용 및 사용하거나, 제품의 택(라벨)이 제거 했거나, 제품을 수선, 수리, 세탁하였을 경우 반품 불가로 표기 된 상품을 구매한 경우 (니트류, 화이트계열, 세일상품 등) 반품 의사를 통보하지 않고 반품한 경우