아두이노용 2.8" TFT 터치쉴드입니다.

헤더핀이 납땜되어 있으므로 그대로 장착 가능합니다.

표준형 아두이노인 UNO, Duemilanove , Diecimila 및 그 호환보드들은 그대로 사용 가능하며,  점퍼 납땜으로 세팅을 변경하면  Leonardo 및 Mega 보드에서도 사용 가능합니다.(튜토리얼 참고)

튜토리얼에 상세한 연결법소개 및  라이브러리와 예제소스코드가 제공됩니다.

튜토리얼 바로가기: https://learn.adafruit.com/adafruit-2-8-tft-touch-shield-v2

DESCRIPTION

Spice up your Arduino project with a beautiful large touchscreen display shield with built in microSD card connection. This TFT display is big (2.8" diagonal) bright (4 white-LED backlight) and colorful (18-bit 262,000 different shades)! 240x320 pixels with individual pixel control. It has way more resolution than a black and white 128x64 display. As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen. (We also have a capacitive-touch version of this shield here)

We've updated our original v1 shield to an SPI display - its a tiny bit slower but uses a lot less pins and is now much easier to use with Mega & Leonardo. We also include an SPI touchscreen controller so you only need one additional pin to add a high quality touchscreen controller. Even with all the extras, the price is lower thanks to our parts sourcing & engineering skillz!

The shield is fully assembled, tested and ready to go. No wiring, no soldering! Simply plug it in and load up our library - you'll have it running in under 10 minutes! Works best with any classic Arduino (UNO/Duemilanove/Diecimila). Solder three jumpers and you can use it at full speed on a Leonardo or Mega as well.

This display shield has a controller built into it with RAM buffering, so that almost no work is done by the microcontroller. This shield needs fewer pins than our v1 shield, so you can connect more sensors, buttons and LEDs: 5 SPI pins for the display, another pin for the SPI touchscreen controller and another pin for uSD card if you want to read images off of it.

Of course, we wouldn't just leave you with a datasheet and a "good luck!" - we've written a full open source graphics library that can draw pixels, lines, rectangles, circles and text. We also have a touch screen library that detects x, y and z (pressure) and example code to demonstrate all of it. The code is written for Arduino but can be easily ported to your favorite microcontroller!

For people who want the same screen but not in a shield form-factor, check out our 2.8" TFT breakout

Adafruit 2.8" TFT Touch Shield v2 - Capacitive or Resistive

Spice up your Arduino project with a beautiful large touchscreen display shield with built in microSD card connection.