SpiUartTermina 샘플 예제 질문입니다.
쉴드를 납땜하고 예제를 돌려보는데 저번과는 틀리게 잘 나오는것 같습니다.
그런데 $$$ 커멘드 모드 진입후 어떻게 작동 시켜야 하는지 질문드립니다.
SPI UART on WiFly Shield terminal tool
--------------------------------------
This is a tool to help you troubleshoot problems with the WiFly shield.
For consistent results unplug & replug power to your Arduino and WiFly shield.
(Ensure the serial monitor is not open when you remove power.)
Attempting to connect to SPI UART...
Connected to SPI UART.
* Use $$$ (with no line ending) to enter WiFly command mode. ("CMD")
* Then send each command followed by a carriage return.
Waiting for input.
CMD
ACTION scan
데이터 쉬트 봐도 정보가 잘 나오지 않아서 질문드립니다.
$$$ 입력후 CMD라고 나왔습니다.
근데 그 어떤 명령어를 입력해서 테스트 해봐야 하는건가요? ^^
초보적인 질문 드려서 죄송합니다.
아무리 검색해봐도 잘 나오지 않아 질문드립니다.
회원에게만 댓글 작성 권한이 있습니다.